Repozytorium Uniwersytetu Zielonogórskiego

Uciński, Dariusz Patan, Maciej (1975- ) Korbicz, Józef (1951- ) - red. Uciński, Dariusz - red.

2010

artykuł

AMCS, Volume 23 (2013)

Nonlinear state observers and extended Kalman filters for battery systems

Rauh, Andreas Butt, Saif S. Aschemann, Harald Korbicz, Józef (1951- ) - red. Uciński, Dariusz - red.

2013

artykuł

AMCS, Volume 15 (2005)

Identifiability and estimation of pharmacokinetic parameters for the ligands of the macrophagemannose receptor

Verdiere, Nathalie Denis-Vidal, Lilianne Joly-Blanchard, Ghislaine Domurado, Dominique Beliczyński, Bartłomiej - red.

2005

artykuł

AMCS, volume 11 (2001)

Identification of a quasilinear parabolic equation from final data

Fernández, Luis A. Pola, Cecilia Triggiani, Roberto- ed. Maksimov, Vyacheslav I. - ed.

2001

artykuł

AMCS, Volume 21 (2011)

Modeling of reliability characteristics typically assumes that components and systems fail if a certain individual damagelevel is exceeded. Every (mechanical) system damage increases irreversibly due to employed loading and (mechanical)stress, respectively. The main issue of damage estimation is adequate determination of the actual state-of-damage. Severalmathematical modeling approaches are known in the literature, focusing on the task of how loading effects damageprogression (e.g., W¨ohler, 1870) for wear processes. Those models are only valid for specific loading conditions, a prioriassumptions, set points, etc. This contribution proposes a general model, covering adequately the deterioration of a setof comparable systems under comparable loading. The main goal of this contribution is to derive the loading?damageconnection directly from observation without assuming any damage models at the outset. Moreover, the connection is notinvestigated in detail (e.g., to examine the changes in material, etc.) but only approximated with a probabilistic approach.The idea is subdivided into two phases: A problem-specific relation between loading applied (to a structure, which contributesto the stress) and failure is derived from simulation, where a probabilistic approach only assumes a distributionfunction. Subsequently, an adequate general model is set up to describe deterioration progression. The scheme will beshown through simulation-based results and can be used for estimation of the remaining useful life and predictive maintenance/control.Keywords: reliability, parameter estimation, damage accumulation, probabilistic simulation.

Dettmann, Kai-Uwe Söffker, Dirk Korbicz, Józef (1951- ) - red. Uciński, Dariusz - red.

2011

artykuł

AMCS, volume 9 (1999)

Parameter estimation based fault detection and isolation in Wiener and Hammerstein systems

Janczak, Andrzej Korbicz, Józef (1951- ) - red. Patton, Ronald J. - red.

1999

artykuł

AMCS, volume 17 (2007)

Iterative estimators of parameters in linear models with partially variant coefficients

Hu, Shaolin Meinke, Karl Chen, Rushan Huajiang, Ouyang Korbicz, Józef (1951- ) - red.

2007

artykuł

IJAME, volume 29 (2024)

Process parameters influence the mechanical properties and nugget diameter of AISI 316 stainless steel during resistance spot welding

Hamzah, Mahmood Mohammed Barrak, Osamah Sabah Abdullah, Isam Tareq Hussein, Sabah Khammass Jurczak, Paweł - red.

2024

artykuł

AMCS, Volume 22 (2012)

Distributed scheduling of sensor networks for identification of spatio-temporal processes

Patan, Maciej (1975- ) Korbicz, Józef (1951- ) - red. Uciński, Dariusz - red.

2012

artykuł

AMCS, Volume 22 (2012)

Sensor network scheduling for identification of spatially distributed processes

Uciński, Dariusz Korbicz, Józef (1951- ) - red. Uciński, Dariusz - red.

2012

artykuł

AMCS, volume 10 (2000)

Optimal selection of measurement locations for parameter estimation in distributed processes

Uciński, Dariusz Korbicz, Józef (1951- ) - red. Uciński, Dariusz - red.

2000

artykuł

AMCS, volume 18 (2008)

Configuring a sensor network for fault detection in distributed parameter systems

Patan, Maciej (1975- ) Uciński, Dariusz Korbicz, Józef (1951- ) - ed. Sauter, Dominique - ed.

2008

artykuł

AMCS, volume 10 (2000)

Spatial heterogeneity and local oscillation phase drifts in individual-based simulations of a prey-predator system

Waniewski, Jacek Jędruch, Wojciech Arino, Ovide - ed.

2000

artykuł

AMCS, volume 10 (2000)

Variable- and fixed-structure augmented interacting multiple-model algorithms for manoeuvring ship tracking based on new ship models

Semerdjiev, Emil Mihaylova, Ludmila Korbicz, Józef (1951- ) - red. Uciński, Dariusz - red.

2000

artykuł

AMCS, Volume 26 (2016)

An integrodifferential approach to modeling, control, state estimation and optimization for heat transfer systems

Rauh, Andreas Senkel, Luise Aschemann, Harald Saurin, Vasily V. Kostin, Georgy V. Korbicz, Józef (1951- ) - red. Uciński, Dariusz - red.

artykuł

AMCS, volume 19 (2009)

Robust parameter design using the weighted metric metod - The case of "the smaller the belter"

Ardakani, Mostafa Kamali Noorossana, Rassoul Niaki, Seyed Taghi Akhavan Lahijanian, Homayoun Korbicz, Józef (1951- ) - ed.

2009

artykuł

AMCS, Volume 25 (2015)

On-line parameter and delay estimation of continuous-time dynamic systems

Kozłowski, Janusz Kowalczuk, Zdzisław Korbicz, Józef (1951- ) - red. Uciński, Dariusz - red.

artykuł

AMCS, volume 13 (2003)

Selecting differentially expressed genes for colon tumor classification

Fujarewicz, Krzysztof Wiench, Małgorzata Kimmel, Marek - red. Lachowicz, Mirosław - red. Świerniak, Andrzej - red.

2003

artykuł

Filtry

Wyników: 18

Sensor network design for the estimation of spatially distributed processes

Nonlinear state observers and extended Kalman filters for battery systems

Identifiability and estimation of pharmacokinetic parameters for the ligands of the macrophagemannose receptor

Identification of a quasilinear parabolic equation from final data

Parameter estimation based fault detection and isolation in Wiener and Hammerstein systems

Iterative estimators of parameters in linear models with partially variant coefficients

Process parameters influence the mechanical properties and nugget diameter of AISI 316 stainless steel during resistance spot welding

Distributed scheduling of sensor networks for identification of spatio-temporal processes

Sensor network scheduling for identification of spatially distributed processes

Optimal selection of measurement locations for parameter estimation in distributed processes

Configuring a sensor network for fault detection in distributed parameter systems

Spatial heterogeneity and local oscillation phase drifts in individual-based simulations of a prey-predator system

Variable- and fixed-structure augmented interacting multiple-model algorithms for manoeuvring ship tracking based on new ship models

An integrodifferential approach to modeling, control, state estimation and optimization for heat transfer systems

Robust parameter design using the weighted metric metod - The case of "the smaller the belter"

On-line parameter and delay estimation of continuous-time dynamic systems

Selecting differentially expressed genes for colon tumor classification

Dane kontaktowe

Adres

Telefon

E-Mail

Odwiedź nas!

Mapa strony

Strona główna

Kolekcje

Indeksy

Informacje

Konto użytkownika

Historia przeglądania